Deep Cycle Batteries
Charging and Discharging
The Golden Rules Are:
|General Charging Advice|
|General Discharging info.||
|Use the Right Charger.||
|Topping up Levels||
If using Solar charging then you will need a Solar Controller or Solar Regulator to avoid over-charging the battery. These are normally purchased separately from the Solar Panel, with the exception of some “fold up” or “suitcase” style solar panels which have them built-in.
We have plenty of models in stock (both Panels and Regulators) and good practical experience with fitting Solar to caravans & Motorhomes so would be happy to advise. Many panels these days come with a silicon diode built in to avoid reverse discharge of the battery via the panel, but this is NOT sufficient to protect the battery from over-charging by the panel and a regulator must be used on all panels above a few watts in power.
Note that the latest MPPT (Maximum Power Point Tracking) solar regulators can provide up to 97% efficiency, which is a big improvement on older style regulators. This can be an advantage where space is tight and a larger panel is not an option.
Do remember to set the Solar Controller / Regulator to suit the battery type if there is an option to do so (as Gel batteries for example require a lower charging voltage, while Calcium batteries can benefit from a much higher (up to 16Volt) Equalisation charge periodically. This is something many Morningstar and other good quality regulators can provide. If in doubt please contact us for more information.
We stock a wide variety of fixed and folding Solar panels with associated regulators / charge controllers.
In general car or van Alternators work reasonably well with Lead Acid and AGM batteries (not GEL). They are not battery chargers however and will never fully charge a Deep Cycle battery to 100% (see table above for reasons), so its best to use a battery charger when mains power is available to top up the battery charge and avoid reduced battery life from sulphation.
Note that alternator output voltages are often reduced by cable/wiring runs and Dual Battery systems so care needs to be taken to measure the actual voltage received at the battery across its terminals to ensure its adequate to charge the battery fully.
Conversely for Gel batteries fitted close to the alternator (under-bonnet with a thick gauge cabling) there is a real risk of damage due to over-charging as the alternator output can be too high for the battery.
Many Portable Generators do not have battery charging circuitry built-in and should be used with care if they provide a DC outlet (although you could plug a battery charger into the 240V socket).
The later models (from Honda etc.) with the built in chargers can provide a reasonably quick and efficient battery top-up on sites where they are allowed (or when off-site), although many users do grow tired of the noise and migrate to solar over time.
Finally many combinations of the above can work well. It can be difficult to fault find on systems with combined charging, although the better Solar regulators often allow the load to be isolated from the panel which can help (and assuming it has been wired up correctly – many are not).
We would be happy to advise but in general would recommend owning a good quality fully automatic battery charger to suit the batteries you are trying to maintain and using it regularly.
We stock a wide range including CTEK, Matson , Victron and Projecta to name just a few, please contact us for advice or pricing. Note that a good quality battery charger, if used regularly, will pay for itself over time through extended battery life and by operating more efficiently than the older style chargers. Some of our wide selection of Battery Chargers are now available online.
Again we would be happy to provide advice on the right charger for your deep cycle battery. There is some more general advice in our Deep Cycle Help & FAQ section.